PP Engine Inspection

Refer to Figure 1. Determine which portion of the AD is applicable for Model )-690 series engine, serial No. 5863-40 with 283 hours time in service.

A Cessna 180 aircraft has a McCauley propeller Model No. 2A34C50/90A. The propeller is severely damaged in a ground accident, and this model propeller is not available for replacement. Which of the following should be used to find an approved alternate replacement?

Which of the following is used to monitor the mechanical integrity of the turbines, as well as to check engine operating conditions of a turbine engine?

On a reciprocating engine aircraft using a shrouded exhaust muffler system as a source for cabin heat, the exhaust system should be

(1) Airworthiness Directives are Federal Aviation Regulations and must be complied with unless specific exemption is granted.

(2) Airworthiness Directives of an emergency nature may require immediate compliance upon receipt.

Regarding the above statements,

Which of the following contains a minimum checklist for 100-hour inspections of engines?

When must an Airworthiness Directive (AD) be complied with after it becomes effective?

Which of the following contains a table that lists the engines to which a given propeller is adaptable?

Which of the following component inspections is to be accomplished on a 100-hour inspection?

You are performing a 100-hour inspection on an R985-22 aircraft engine. What does the “985” indicate?

Where would one find type design information for an R1830-92 engine certificated under the Civil Air Regulations (CAR) and installed on a DC-3?

Straightening nitrided crankshafts is

The breaking loose of small pieces of metal from coated surfaces, usually caused by defective plating or excessive loads, is called

Each powerplant installed on an airplane with a Standard Airworthiness Certificate must have been

A severe condition of chafing or fretting in which a transfer of metal from one part to another occurs is called

Indentations on bearing races caused by high static loads are known as

When inspecting an aircraft reciprocating engine what document is used to determine if the proper magnetos are installed?

Which of the following can inspect and approve an engine major repair for return to service?

What publication is used for guidance to determine whether a powerplant repair is major or minor?

The airworthiness standards for the issue of type certificates for small airplanes with nine or less passenger seats in the normal, utility, and acrobatic categories may be found in the

Which of the following contains approved data for performing a major repair to an aircraft engine?

What maintenance records is/are required following a major repair of an aircraft engine?

A ground incident that results in propeller sudden stoppage would require a crankshaft runout inspection. What publication would be used to obtain crankshaft runout tolerance?

Select the Airworthiness Directive applicability statement which applies to an IVO-355 engine, serial number T8164 with 2,100 hours total time and 300 hours since rebuiliding.

What publication contains the mandatory replacement time for parts of a turbine engine?

How is the flow range of the fuel discharge nozzles installed in a fuel injected reciprocating engine indicated?

What section in the instructions for continued airworthiness is FAA approved?

Which of the following conditions is usually not acceptable to any extent in turbine blades?

(1) Serviceability limits for turbine blades are much more stringent that are those for turbine nozzle vanes.

(2) A limited number of small nicks and dents can usually be permitted in any area of a turbine blade.

Regarding the above statements,